SUNUV 1-Lampe LED UV 48 W

Technical features

LED: 30 x 5050 SMD LEDs

Power: 48W (With 24/48W selector)

Input: DC24V 1.2A (powered by adapter)

The included power supply has a lower power rating so as not to cause damage to the device.

Power supply: Input 100-240V 50/60Hz 1A Output: DC24V/ 1.2A

Dimensions: 235x 163x 98 mm

Functions

Infrared sensor

ON/OFF switch and 24W - 48W power selection

5s timer 30s timer 60s timer

Operation:

Connect the power supply

Turn on the lamp by pressing the ON button or one of the time adjustment buttons. When the lamp is turned on, press the ON/OFF button once again to turn off the lamp. It is also possible to start it directly using the infrared sensor.

Hold down the ON/OFF button for 2 sec to switch from 24W to 48W power. After turning on the lamp, you can adjust the operating time by pressing the setting buttons.

It is possible to set 5s. 30s and 60s. If it is not necessary to set the time, place your hand directly inside the UV lamp, the infrared sensor will automatically activate the lamp. The longest operating time is 120 sec.

Warnings :

Read the instruction manual carefully before using the UV lamp. Use only with the correct electrical voltage

Avoid letting water or other liquid substances come into contact with the lamp to avoid failure

Do not use the lamp if the time adjustment buttons are faulty

Remove the power cord if the lamp is not used for a long time

Do not use if the power supply is broken, to avoid any danger

Do not use the lamp for more than 600s consecutively to avoid shortening the life of the lamp

Do not expose your eyes to direct contact with the light beam