Kit Semipermanent - Baby Selection 1

How to use:

1. Shake the bottle before use.

2. Disinfect the client's hand with the sanitizing solution.

3. Push the cuticles with the cuticle pusher.

4. Clean the cuticle area well, eliminating dead cells.

5. Matt the surface of the nail plate with the abrasive brick.

6. Carefully dust off all the dust produced with the appropriate brush.

7. Apply Nail Prep and let air dry for approximately 30 seconds.

8. Apply the Ultrabond, let it air dry for about 30 seconds and leave the shiny, tacky layer it produces after drying.

9. Apply a ''Base&top2in1'' gel base

10. Apply two thin layers of Gel Polish Nail Color, taking care not to touch the cuticles. Cure at each step in a 36 WATT UV lamp for 2 minutes or 1 minute in a 36 Watt LED lamp (leave the sticky layer!). If using a lower wattage lamp, extend the curing time by 1-2 minutes.

11. Apply Gel Polish Base&Top to seal the job, being careful not to touch the cuticles. Cure in a 36 WATT UV lamp for 4 minutes or 2 minutes in an LED lamp (36 Watt).

12. Degrease with the UV Gel Cleanser solution to finish the job.

HOW TO REMOVE:

1. Mattify the shiny surface of the nail polish with a 100/180 file, being careful not to damage the natural nail.

2. Dip your fingers in the Soak-Off Remover or apply a pad soaked in solvent to each nail, wrap with aluminum foil and leave on for 10-20 minutes depending on the system used.

3. Remove the softened nail polish with a cuticle pusher.

Contents: 8ml x6

Made in USA - For PROFESSIONAL USE only